Product Name:
Enamel Camp Mug for Sublimation with Metal Rim and Handle, Glossy White Finish
Directions:
- Apply sublimation transfer on the surface of the tumbler using heat tape.
- For full wrap designs, make sure you pull the transfer as tightly as possible around the tumbler, then tape very well along the seam and around the top/bottom of the tumbler.
- Pulling the tape/transfer as tight as possible with no air pockets.
- If your transfer does not fully cover the tumbler surface, apply blowout/butcher paper to the entire tumbler so that no metal is showing on the sides.
PLEASE NOTE:
- equipment varies and so may your required settings.
- Please test your equipment using these baseline recommendations.
Tumbler Press:
- Camp mugs should be pressed 2 at a time! (one on each end of the tumbler press)
- If you only need to add a design to one mug, put a blank mug on the other side of the press to ensure even pressure and heat distribution while pressing.
- Insert a camp mug into each end of the tumbler press attachment and place the handle as close to one side of the opening as possible.
- Pressure should be light, but evident, using about 2 fingers to close and open the press.
- Press at 360 for 90 seconds, then turn the handle to the other side of the opening and repeat the press.
- Remove the hot mug from the press and carefully remove the transfer paper.
- Let the cup cool before handling.
Note:
- Equipment settings and functions may vary.
- These settings are on our Elite Pro Max tumbler press offered in the shop
Additional Notes:
- Sublimation does NOT require the use of any type of sealant.
- It is recommended to handwash all cups/tumblers to ensure the images remain their most vibrant.