Lighted ELF dual lid lantern and “snow globe” tumbler with hanging hardware, solar powered lid with light, bamboo lid with straw, double walled glass tumbler RTS ACC Sublimation Blanks & Designs

Product Name:

Glass Can Cups for Sublimation

Product Details:

• Material: Clear double-walled “snow globe” glass, sublimation ready
• Design: Features a hole in the bottom to fill with glitter/fluid and then seal with UV resin
• Preparation: Glass MUST be sublimated before filling with glitter/fluid and then sealed with UV resin

Usage:

It can be used in a mug/tumbler press or convection oven.

Convection oven requires the use of shrink wrap to apply pressure during baking, sold separately, and accessories such as metal straws and straw cleaning brushes are also available in a separate listing

Directions:

• Apply sublimation transfer on the surface of the tumbler using heat tape.
• For full wrap designs, make sure you pull the transfer as tightly as possible around the tumbler, then tape very well along the seam and around the top/bottom of the tumbler.
• Pulling the tape/transfer as tight as possible with no air pockets.

PLEASE NOTE:

• equipment varies and so may your required settings.
• Please test your equipment using these baseline recommendations.

Tumbler Press:

• Press at 360°F for 120 seconds, then turn the tumbler halfway and press again for another 120 seconds.
• If the design is darker, an additional few seconds may be required.
• Remove the transfer and let cool.

PLEASE NOTE:

• Equipment settings and functions may vary.
• These settings are on our Elite Pro Max tumbler press offered in the shop.
• Make sure your pressure is very light!!!             

Convection Oven: (Equipment settings will vary!)

• Apply shrink wrap using a heat gun to shrink it tight to the tumbler.
• Bake in a convection oven at approximately 385-400 degrees F for 6.5-8 minutes, turning halfway.
• If your tumbler is touching a metal surface during baking, the shrink wrap will be more likely to melt!
• Remove from oven and immediately remove shrink wrap and transfer.
• GLASS WILL BE HOT!! No sealant is necessary for sublimation.

Cleaning:

Hand washing is recommended as the high heat in many dishwashers may reactivate the ink and cause it to bleed.

PLEASE NOTE:

As with all glass products, avoid extreme temperature changes, as this may cause cracking or even explosion of the glass.

Personalization:

The bamboo lid can be engraved using a laser engraver or wood-burning tool for added customization options.